Category Name: Vibration Visual Analyzer
Product Name: Vshooter machine condition and Vibration visualizer
The Vshooter VBSIT is much more than a innovation in the field of the vibrometers, it is a totally new concept, a new way to do vibration monitoring and analysis. This new modern concept consists of creating automatically Machine Condition Pictures (MCP) which can be saed and uploaded to a PC in to a report with detailed vibration datas and trending curves. With a MCP you see immediately the machine condition. After having done the second MCP on the same machine you'll be able to follow the machine condition evolution on a trending curve.
Take a photo, do the measurements and get the MCP (Machine Condition Picture) to see the machine condition, if maintenace needed at a glance. Quick, easy to use, with automatic auto diagnosis system for beginners and experts.
The Vshooter is a comprehensive diagnostic tool a vibrometer that allows to know and to easily track the status of the more common rotating machines such as fans, pumps, screw compressors etc.
The V shooter VBSIT produces the MCP. The Vshooter VBSIT is a portable measuring device, a vibrometer equipped with an external high quality accelerometer, an embedded camera, led stroboscope and pyrometer. A special software has been developed to get photos enhanced with informations. On every MCP appear the measuring points locations. The points appera in green, yellow, orange or red according to the classification of ISO 10816-3 7.
The vibrations of newly installed machines are normally placed in green zone.
The machines whose vibrations are with in yellow zone are normally considered acceptable for a long service life with out any restrictions.
Machines whose vibrations are in orange zone are normally considered unsuitable for long-term continuous service. In general, the machine can operator in these conditions for a limited time, until the opportunity arises to take corrective action where necessary.
The vibration values found in red area are normally considered significant enough to cause damage.
Every MCP, condition picture, with all the vibration measurements related to can be stored in the memory of the Vshooter. Up to 1000 MCP can be stored and uploaded to a PC by mean of the USB cable supplied.
For measurements values with in zone oragne and red the Vshooter VBSIT automatically performs a self diagnosis and the FFT of the velocity and the Acceleration. On the FFT screens the user is directed automatically to one of the 5 most common defects (75% of faults): unbalance, bearing shock, and lubrication, alignment, foundation. In case of none of these defects being detected it is recommended to use a more powerful analyser.
On clicking on the table of all the measurements made on a machine will be displayed. On clicking on the FFT of the velocity and acceleration of all the measurements on alarm, orange and red according to ISO 10816-37, will be displayed. For the velocity the 3 frequencies with the largest amplitude will also be displayed together with the self diagnosis.
As part of the preventing maintenace the Vshooter VBSIT allows for monitoring of rotating machines by performing for each measurement trends of 4 values:
- Vibration Rms velocity 2(10)-1000Hz in mm/s or inch/s according to ISO 10816-37
- Vibration Rms acceleration 1000-10000Hz in G
- Vibration Crest acceleration 1000-10000Hz
Multimeter mode and Fusion moderately
- The Vshooter VBSIT has two operating modes: Fusion and Multimeter.
- On the fusion mode the operator will create MCP's as explained above.
- On the multimeter mode the operator will only do measurements on the spot with out creating MCP's.